This device is capable of use without decreasing
the servo performance, it accents the
resolution and smoothness especially on
Giant scale Airplanes, and excessive hunting
can be reduced.Be sure to apply JR “Super
Grease” in between the moving surface of
servo arm and around the servooutput shaft
area on top servo case. (Note: It is suggested
to use the “Poly Slider” plastic washer between
the dampener with Super Grease applied
on both sides)
【 Warning】
Having too many dampener plates can cause
too much friction causing high current
draw and damage to the servo. Be sure to
check that servo movement is not too tight
when dampener plate is installed.
Also note that the gap between the servo
arm and around the servo output shaft area
on top of the servo case may differ depending
on the type of servo arm installed. Be
sure that there is enough gap between the
servo case and servo arm to install this dampener
plate.
■It is suggested to use an amp meter to check the amperage while the servo is without the control surface load (disconnect the linkage to the control surface). Current should be within 0.1A to 0.2A as maximum current comparison of not having dampener plate.
■Be sure to check that servo movement is not too heavy load by having dampener plate installed. Also note that gap between the Servo arm and around the servo output shaft area on top servo case may be different depend on the installation of the arm or the type of Servo manufacturer. Be sure that there is an enough gap between to install this dampener plate.